AGGREGATE MOISTURE (ASTM C566)
MOISTURE CONTENT
DATA AND TABULATION
Mass of Container, Mc = _______35____g.
Mass of Container + original sample, Mc+w = ______520___g.
Mass of container + dried sample, Mc+D = ____472______g.
Mass of original sample, W = _______g.
Mass of Dried sample, D = ________g.
MOISTURE CONTENT
DATA AND TABULATION
Mass of Container, Mc = _______35____g.
Mass of Container + original sample, Mc+w = ______520___g.
Mass of container + dried sample, Mc+D = ____472______g.
Mass of original sample, W = _______g.
Mass of Dried sample, D = ________g.
Steel bar having a rectangular cross section 15mmx20mm and 11 m long is suspended vertically from one end. The steel has a unit mass of 7850 kg/cu.m. and E=200GPa. If the load of 20kN is suspended at the other end of the rod, determine the total elongation of the rod.
A steel pipe 1m in diameter is required to carry an internal pressure of 750 kPa, if the allowable tensile stress of steel is 140 MPa, determine the required thickness of the pipe in mm.
An axial load of 100 kN is applied to a flat bar 20 mm thick, tapering in width from 120 mm to 40 mm in a length of 10 m. Assuming E = 200 GPa, determine the total elongation of the bar.
1. Do the experimental and theoretical values of voltages and currents agree?
2. Give possible reasons for any discrepancies.
3. Are KVL and KCL verified?
4. Give reasons for any discrepancies.
10. A supercritical power generates steam at 25 Mpa and 560 oC. The condenser pressure is 7 kpa. Determine the exit quality of steam if it expands through a turbine in this power plant. PLEASE EXPLAIN THE DETAILED SOLUTION.
Answer: a. 45.66% c. 56.66%
b. 68.45% d. 74.26%
A Diesel cycle has a compression ratio of 16. The lowest and highest temperature of the
cycle are 300K and 1880K respectively. The pressure at the beginning of compression is 1 Bar.
Calculate:
a) The pressure and temperatures at all the other points of the cycle.
b) Net work output.
c) Efficiency of the cycle.
An open cylindrical tank 4 ft in diameter and 6 ft deep is filled with water and rotated about it's axis at 60 rpm. How much liquid is spilled, and how deep is the water at the axis?
1.Aside from area by triangles, what are other common methods used in determining/ measuring the required area?
2. What are the similarities and/or differences of each method?