Computer Networks Answers

Questions: 1 204

Answers by our Experts: 1 122

Need a fast expert's response?

Submit order

and get a quick answer at the best price

for any assignment or question with DETAILED EXPLANATIONS!

Search & Filtering

What do you think? How does technology affect human relationships?

In today's modern living, how important is information technology?

A protocol using sliding window starts sending packets to a receiver. SWS = RWS = 10. Sender must send 25 unique packets to the receiver and 15 sequence numbers are available (0-14). During transmission ACKs of 8th,9th and 10th packet are lost.Will the transmission end normally or there will be errors during the transmission?


1a) State the contents of the accumulator after the following instructions

have been executed. The memory location with address 200 contains

300, the memory location with address 300 contains 50.

i) LDM #200 

ii) LDD 200 

iii) LDI 200 


b) Write an assembly language instruction to: 

i) compare the accumulator with 5 

ii) jump to address 100 if the comparison is true.


CAT-6 twisted pair cable is a commonly used computer networks cable that provides a frequency bandwidth of up to 250 MHz. It is suitable for most varieties of Ethernet over twisted pair up to 1000 BASE-T (Gigabit Ethernet). Determine whether a signal-to-noise ratio (SNR) of 20 dB is adequate to transmit 0.9 Gbps on this cable?

CAT-6 twisted pair cable is a commonly used computer networks cable that provides a frequency bandwidth of up to 250 MHz. It is suitable for most varieties of Ethernet over twisted pair up to 1000 BASE-T (Gigabit Ethernet). Determine whether a signal-to-noise ratio (SNR) of 20 dB is adequate to transmit 0.9 Gbps on this cable?


CAT-6 twisted pair cable is a commonly used computer networks cable that provides a frequency bandwidth of up to 250 MHz. It is suitable for most varieties of Ethernet over twisted pair up to 1000 BASE-T (Gigabit Ethernet). Determine whether a signal-to-noise ratio (SNR) of 20 dB is adequate to transmit 0.9 Gbps on this cable?


A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in Figure 1. a. What kind of a network is this? (1 Mark) b. Ping attempts between the hosts are unsuccessful. What are the two possible solutions for proper connectivity between the hosts? (2 Marks) Figure 1


Using an example, illustrate how checksum is used in error correction and detection. 


Using a diagram, illustrate and explain how twisted pair reduces signal interference


LATEST TUTORIALS
New on Blog
APPROVED BY CLIENTS