Search
Design, using SR flip-flops and an external input x, a circuit that will count modulo 10 (i.e. from zero to nine, then back to zero and repeat). The circuit should only count when x = 1. If x = 0, there should be no change of state. Show all the steps involved.
a. Draw the State diagram
b. From the state diagram, derived the circuit excitation and output/state table
c. Use K-maps to derive the necessary logic equations for the flip-flop inputs
d. Draw the sequential circuit.
Design sequential circuit with two JK flip-flops A and B and two inputs E and x. If E = 0 the circuit remains in the same state regardless of the value of x. When Ex = 11; the circuit goes through the transitions from 00 → 01→ 10 → 11 → 00, and repeat. When Ex = 10, the circuit goes through the state transitions from 00 → 11 → 10 → 01 → 00, and repeat.
Consider an SDOF system of mass m, stiffness k, and damping coefficient c. Now if the mass of the system increases 4 times, what will be the change in the damping ratio?
no changes
become half
increases by 2 times
increases by 4 times
Suppose you have to design a box in that has an expensive product in it, if the mass of the item 100 gm, there is some stuffing material in this box which providing some kind of flexibility to this item that is inside say 10N/m. Now if the box is lifted 3m above the ground to carry it from one place to another then what is the vertical dimension of the box
160 cm
165 cm
170 cm
175 cm
An oil storage tank has 20mm steel walls covered with 50mm of fiber glass insulation. if the oil temperature is kept at 150 degree Celsius, what is the rate of heat loss when the outside temperature is 20 degree Celsius and external air coefficient is 20W/m². How much would the heat loss be reduced by doubling the thickness of the insulation?
Write a Verilog code for Mealy FSM to detect 0101 sequence with overlapping in behavioral
modeling.
3. Find the angle of the largest right circular cone which can be inscribed in a sphere of
radius 9 inches.
4. A statue 10 feet high is standing on a base 13 feet high. If an observer’s eye is 5 feet
above the ground, how far should he stand from the base in order that the angle
between his lines of sight to the top and bottom of the statue is a maximum. (How far
should he stand to get the best view of the statue.
5. A steel girder 27 feet long is to be moved on rollers along a passageway 8 feet in
width and into a corridor at right angles to the passageway. If the horizontal width of
the girder is neglected, how wide must the corridor be in order that the girder can go
around the corner?
At what point on the line y = b does the line segment from (0,0) to ( a,0) subtend the
greatest angle.
n the right triangle ABC, AB = 2, BC = 4 and ED is a line parallel to AB. Find the
angle α = angle BAD which minimizes the distance L, where L = AD + ED
Calculate the maximum value of the e.m.f. generated in a coil which is rotating at 50 rev/s in a uniform magnetic field of 0.8 Wb/m2. The coil is wound on a square former having sides 5 cm in length and is wound with 300 turns
