Other Math Answers

In this chapter a decision tree was developed for John Thompson. After completing the analysis, John was not completely sure that he is indifferent to risk. After going through a number of standard gambles, John was able to assess his utility for money. Here are some of the utility assessments: U( - $190,000) = 0, U( - $180,000) = 0.15,
U(- $30,000) = 0.10, U(-$20,000) = 0.15,
U (-$10,000) = 0.2, U($0) = 0.3,
($90,000) = 0.5, U($100,000)=0.6 U=($190,000)=.95
and U($200,000) = 1.0. If John maximizes his expected utility, does his decision change?

If cybertron Jetfire's plane mode was the same as the real Mriya what weight, height and wingspan would he have

Your measuring jug has only imperial measurements on the side. How much would you need in approximate imperial measurements (fluid ounces) to wash a very dirty load? 10 fluid ounces is equivalent to half a pint and 275 millilitres.

Very dirty=200 ml Reasonably dirty =160ml Not very dirty=140ml

Can someone help me solve this problem in a very simple way
thank you
uk measurements pls

Give a proof for the sequent using only primitive proof rules.

PvQ l- ~(~P&~Q)

Find the true speed and bearing.
Wind vector: N11E (degrees) @55mph
Airspeed: 500mph
Direct fight bearing: N35.2E (degrees)

Christine has $875.83 in her savings account.
The account pays 9% compounded monthly.
Christine does not make any deposits or withdrawals over the next 6 months.
How much interest does the account earn?

Consider the following grammar.
S → ( S )
S → x
Which of the following statements is (are) true?
S → ( S )
S → x
I. The grammar is ambiguous.
II. The grammar is suitable for top-down parsing.
III. The grammar is suitable for bottom-up parsing.
(A) I only (B) II only (C) III only (D) II and III only (E) I, II, and III

Hi, I'm doing a project for college and I've hit a stumbling block.

Essentially I'm designing a large 120ft tape measure. Tape width 50mm and height 1mm.

I need to find the reel size of this tape when fully retracted so that I can design the case.

Any help would be greatly appreciated!
Cheers

Hi, I'm doing a project for college involving essentially a huge torsion spring loaded tape measure.

I've been struggling with this problem for a while and no matter how much i research I cannot find a solution! Basically, I need to work out the reel diameter if all of my tape is retracted fully.

The tape is 50mm wide and 1mm thick and 120ft long.
Any help would be much appreciated!

In an enhancement of a design of a CPU, the speed of a floating point unit has been increased by 20% and the speed of a fixed point unit has been increased by 10%. What is the overall speed up achieved if the ratio of the number of floating point operations to the number of fixed point operations is 2:3 and the floating point operation used to take twice the time taken by the fixed point operation in the original design?

a) 1.155
b) 1.185
c) 1.255
d) 1.285