Answer to Question #262911 in Mechanical Engineering for Harshit

Question #262911

design a flat belt (cross) to drive. the center distance between shafts is 5 m, velocity ratio=2.25, angular speed 600 rpm of the driving pulley, 60 hp, light shock.

Expert's answer

Diagram with tables is given below for designing belt ;

Learn more about our help with Assignments: Mechanical Engineering

Comments

No comments. Be the first!

Leave a comment

Related Questions

1. a one dimensional steady flow is given by the following velocity;"u=\\frac{2}{\\gamma+1}(\\frac xt-a
2. Explain the difference between an isothermal and an adiabatic expansion of a gas . 20020 m ^ 3 the g
3. Explain briefly why a gas has two specific heat capacities.0.28 kg of a gas is heated from 29 °C t
4. An air compressor works with a compression ratio 6:1 . If the incoming air is at a pressure of 1 bar
5. A simple hydraulic jack has a pump piston diameter 38.13 mm , and a load piston 190.65 mm . Calculat
6. A manometer is used to measure the gas pressure supply to a boiler. One side is connected to the sup
7. A journal runs in a bearing diameter , 25mm , and length 100 mm at 25 . The clearance gap is 0.8 mm

Who Can Help Me with My Assignment

There are three certainties in this world: Death, Taxes and Homework Assignments. No matter where you study, and no matter…
How to Finish Assignments When You Can’t

Crunch time is coming, deadlines need to be met, essays need to be submitted, and tests should be studied for.…
How to Effectively Study for a Math Test

Numbers and figures are an essential part of our world, necessary for almost everything we do every day. As important…