Answer to Question #247176 in Mechanical Engineering for mds

Question

Question 1 1.1. Use EASYEDA to Design the following electrical circuit, and determiner the voltage across resistor 1 to resistor 5. (7) 1.2. From 1.1 one use EASEDA to design the equivalent circuit and measure the voltage across the R equivalent. (3) [10] Question 2 2.1. Use EASYEDA to Design the following electrical circuit in figure 2, and determiner the voltage across resistor 1 to resistor 6. (7) 2.2. From 2.1 one use EASYEDA to design the simplified circuit and measure the voltage across the R total. (3) [10]

Answer 1

This type of cable is a bit more complicated than the unbuffered one, although it is also fairly easy to construct. The cable most often used in this category is the so-called Wiggler cable. The Wiggler is a commercial cable sold by Macraigor Systems. With a list price of $150 USD they are not cheap. There is a schematic on the internet that is commonly accepted to be the equivalent of what's inside a Wiggler cable. This schematic, by Alec, was drawn up for devices that implement a typical EJTAG header in devices based on the ADM5120 System-on-Chip, another design based on the MIPS32 architecture. The ADM5120 has support for EJTAG v2.6, which does not support DMA transfers.