In April 2025
Search & Filtering
A wooden beam with a rectangular section 150mm wide and 250 deep can resist a 140 kN-m bending stress. Determine the maximum compressive and tensile stress in the section if the beam material is non-isotropic with the tensile modulus of elasticity twice the compressive modulus.
1.Draw a bridge from a two point perspective sharing.
2.explain the steps that need to be followed when constructing a two point perspective.
1.identify and draw any rectangular object in third orthographic angle projection.
2.explain in detail the steps followed in question 1.
If the ratio of the greater angle between diagonals of a rectangle to the
smaller angle is 2: 1 and a > b then, the ratio a: b of sides of the rectangle is?
If one side of a parallelogram is 4 cm, other 6 cm, and the diagonal 4√2 cm,
what is the length of the other diagonal?
If the ratio of the greater angle between diagonals of a rectangle to the
smaller angle is 2: 1 and a > b then, the ratio a: b of sides of the rectangle is?
Simple estimate for fencing with angle iron posts 2"×2"× 4 mm thickness, center to center distance of 5' for 60'×90' ( 1 kanal of land) on cement concrete block or S M plinth 3' A G and 1'-6' UG foundation.
A truck is travelling at a certain speed on a straight level road. The breaks were suddenly applied and the motion of the truck can now be approximated by s=t^3/100−t^2+17t, where s is in meters and t is in seconds. What is its (a) speed before the break is applied and (b) the distance travelled before the train stops?
an automobile starting from rest speeds up to 40ft per sec with a constant acceleration of 4 ft per sec2, runs at this speed for a tie, and finally comes to rest with a deceleration of5 ftper sec2.ifthe total distance traveled is 1000ft,find the total time required.
Lines L1(x = 1 + t, y = t, z = 2 + t, t ∈ R) and L2(x - 3 = y - 1 = z - 3) are given.
a. Verify whether lines L1 and L2 are parallel.
b. If the lines L1 and L2 are parallel, then find the distance between them.
