3D CAD Modeling Answers

system hast o ask for the last name, first name and age of the user, If age of the user is greater than or equal to B.

A pipeline connecting two reservoirs having a difference of level of 6m is 720m long and rises to a height of 3m above the upper reservoir at a distance of 240m from the entrance before falling to the lower reservoir.If the pipe is 1.2m in diameter and the frictional coefficient f=0.01,what will be the discharge and the pressure at the highest point of the pipeline?

A reservoir feeds a 200mm diameter pipe 300m long which branches into two 150mm diameter pipes each 150m long.Both the branch pipes are fully open at the ends.One branch has outlets all along its length arranged so that half the water entering it is discharged at the end and the remainder is discharged uniformly along its length through the outlets.The far ends of the branch pipes are at the same level,which is 15m below that of the reservoir.Calculate the discharge from each branch pipe.Disregard all loses except friction and take f=0.006 for all pipes.

Question #26033.
Sharon has started to use both the stock details management and the file information viewer
features of the application. However, while using the file information viewer application, she
accidentally enters the path of a folder that does not exist on her computer. This caused the
application to stop responding. In addition, the format in which the stock details are displayed is
not clear. Therefore, she asks Hayley to modify the application so that:
The file information viewer does not stop responding in case a specified folder does not exist.
The stock details management application adds a line break before every stock details entry
whenever a new entry is added to the stock details file.
Write the code snippets that Hayley should use to address the preceding two requirements

which feature of C# will allow SftSoils inc. to reuse the existing application code. describe in brief.

which feature of c# will allow SoftSols Inc.to reuse the existing application code? Describe in brief.[5 marks].

An engineering company have won a contract to produce 1500 steel rods per month. A trial run was produced to establish process capability. The results were:-

11.80 12.30 12.20 12.4 12.1 12.2 11.9 11.8 11.85 12.15

The specification is 12cm +/- 0.35 cm, and the cost of rejection would be £20 per casting. Average loss should be kept below £4 per unit to avoid making a loss on the contract.

Using Taguchi Loss function, what is the variance in the system and the loss likely to be experienced?