Search
Heat transfer coefficient in laminar flow of a given fluid is (greater /smaller) than than the turbulent flow?
What is the heat flux (in W/m²) through the slab of 10cm thick if temperature drop across the slab is 40°C and the thermal conductivity of slab is 35 W/m.°C.?
10 mm deep and rises again in a total time of 0.8 seconds. The displacement of the wheel
takes place with simple harmonic motion. The wheel has a diameter of 3 m and the distance
between the wheel centres is 1.75 m. The wheel pair with axle has a moment of inertia of
500 kg-m
2
. Determine the magnitude and the effect of gyro-couple produced in this case.
The cranks of a four-cylinder vertical engine are 240 mm long. The reciprocating masses of
the first, second and fourth cranks are 120 kg, 140 kg and 120 kg and the planes of rotation
are 700 mm, 350 mm, and 350 mm from the plane of rotation of third crank. Determine the
mass of the reciprocating parts of the third cylinder
Link
AB
BC
CD
AD
Length
60mm
200mm
100mm
140mm
Mass
MOI about an axis through centre of mass
80 kg. mm 1600 kg. mm
kg. mm
AD is the fixed link. The centres of mass for the links BC and CD lie at their mid-point whereas the centre of mass for link AB lies at A. Find the drive torque on the link AB at the instant when it rotates at an angular velocity of 47.5 rad s counter clockwise and angle DAI is 135 degree. Neglect gravity effects.
The number of teeth on the gear and pinion of two spur gears in mesh are 40 and 24 respectively. Both the gears have a module of 8 mm and pressure angle of 20 degree. If the pinion rotates at 500 rpm, what will be the sliding velocity at the moment the tip of the tooth of the pinion has contact with gear flank? Take addendum equal to one module. Also, find the maximum velocity of sliding.
The number of teeth on the gear and pinion of two spur gears in mesh are 40 and 24
respectively. Both the gears have a module of 8 mm and pressure angle of 20 degree. If the
pinion rotates at 500 rpm, what will be the sliding velocity at the moment the tip of the
tooth of the pinion has contact with gear flank? Take addendum equal to one module. Also,
find the maximum velocity of sliding.
A wheel of a locomotive, travelling on a level track at 120 km / h, falls in a spot hole 10 mm deep and rises again in a total time of 0.8 seconds. The displacement of the wheel takes place with simple harmonic motion. The wheel has a diameter of 3 m and the distance between the wheel centres is 1.75 m. The wheel pair with axle has a moment of inertia of 500 kg-m 2 . Determine the magnitude and the effect of gyro-couple produced in this case.
In a slider crank mechanism, the length of the crank and connecting rod are 100 mm and 400 mm respectively. The crank rotates uniformly at 600 r.p.m. clockwise. When the crank has turned through 45° from the inner dead centre, find, by analytical method : a. Velocity and acceleration of the slider. b. Angular velocity and angular acceleration of the connecting rod. Check your result by Klein’s or Bennett’s construction.
A temperature scale of certain thermometer is given by the relation
t = a ln p + b
where a and b are constants and p is the thermometric property of the fluid in the thermometer.
If at the ice point and steam point the thermometric properties are found to be 1.5 and 7.5
respectively what will be the temperature corresponding to the thermometric property of 3.5 on
Celsius scale.
