Chemical Engineering Answers

a) For a gas reaction at 400K, the rate is reported as -dPA/dt= 3.66 PA^2. What is the value of rate constant for this reaction if the rate equation is measured in terms of mol/ (l. h)?

The indicating liquid in the manometer shown in the figure below is water and benzene with a density of 880 kg/m³. These two liquids are essentially insoluble in each other. If the two liquids are essentially insoluble in each other. If the manometer reading is ΔZ = 37.19 cm of water, what is the pressure difference P₁ - P₂ in kN/m². Show detailed calculations.

A mixture containing 10% ethanol (E) and 90% H₂O (W) by weight is fed into a distillation column at the rate of 106.26 kg/h. The distillate (top product) contains 94.01 % ethanol and the distillate is produced at a rate of one tenth of that of the feed. 

_{Draw and label a flow chart of the process before solving the problem. Perform material (total) and ethanol balances to calculate the mass fraction of ethanol in the bottom product to at least four decimal places.} 

The indicating liquid in the manometer shown in the figure below is water and benzene with a density of 880 kg/m3. These two liquids are essentially insoluble in each other. If the two liquids are essentially insoluble in each other. If the manometer reading is AZ = 43.99 cm of water, what is the pressure difference P1 - P2 in kN/m2.

Please show detailed calculation.

Check the stability of the closed system whose characteristic equation is given by S^4 +4S³ +6S² +2S+3=0,explain with step by step lengthy?

Check the stability of the closed system whose characteristic equation is given by S^4 +4S³+6S² +2S+3=0.

One liter per minute of liquid containing A and B (CAo=0.10 mole/liter, CBo= 0.01mole/liter) flow into a mixed flow reactor of volume V-1 liter. The materials react in a complex manner for which the stoichiometry is unknown. The outlet stream from the reactor contains A, B and C (CA 0.02 mole liter, Cu 0.03 mole liter, Cer=0.04 mole/liter). Find the rate of reaction of A, B and C (ie, rA,rB,rC and to) for the conditions within the reactor? Explain problem with step by step briefly?

Write the differences between feedback control process and feed forward control process briefly?

3. For a gas reaction at 400K, the rate is expressed a -dpA/dt 3.66 atm.h-. What is the unit for the rate constant?

The indicating liquid in the manometer shown in the figure below is water and benzene with a density of 880 kg/m3. These two liquids are essentially insoluble in each other. If the two liquids are essentially insoluble in each other. If the manometer reading is AZ = 43.99 cm of water, what is the pressure difference P1 - P2 in kN/m2.